aca el link con lo que necesitas saber
http://www.maxamps.com/lipo-care.php
Cita:
* Use a motor speed controller which has auto-cut feature for lithium polymer. Auto-cut should be set at 3.0V per cell. A three-cell pack, therefore, should be set for 9.0V auto-cut, for example.
* Don’t leave battery pack plugged into vehicle while not in use. The pack can still discharge to an unsafe level and damage the pack even if all components are turned off.
* Make sure to cycle your packs at least once per month since leaving them on the shelf for a prolonged period can cause the packs to get severely out of balance or even go dead.
* Do not exceed the manufacturer's rated maximum continuous discharge rating!
* USE AN AMPMETER, like An Eagle Tree Data Logger, to confirm the maximum amperage drawn by your motor-batter-propeller combination
* Do NOT count on "unloading" during flight to greatly reduce the current drawn. In most cases this effect is MINIMAL. In the case of High pitch props at high RPM, the in-flight amperage may actually RISE substantially. Factor this into your calculations.
|